Carbon steel splitter bin with primed interior and finish painted exterior. Where applicable UHMW liners will be provided. Two (2) openings with discharge chutes will be provided. The bin will be elevated on a structural steel support frame.

Syntron Model F-24-C-DT Electromagnetic Vibratory Feeder:
24" wide by 42" long Mild Steel flat bottom trough. The trough bottom and sides to be equipped with replaceable ¼" thick T-1A liners. Arranged for below deck drive unit. Suspension mounting at a recommended down slope of 10 degrees in the direction of material discharge. The necessary suspension and safety cables are supplied as part of the splitter bin. Complete with a separate Model C-RSDC-2C variable rate, solid-state control, mounted in a NEMA 4 type enclosure arranged for manual and/or automatic operation. All arranged for operation from a 460-volt, 60-cycle single-phase power source.

Photos

Contact / Additional Info

Please contact Mickey Jones at (303) 514-1403 email mickeyhk@hotmail.com or Greg Jones at (303) 885-2068 email greg@intermountaincrushers.com for further information.

Note: Each of the conveyors mechanical components (frame, bearings, shafting, gear boxes, take-ups, etc.), except motors are designed for 950 STPH for the 30" wide conveyors (1300 STPH for 36" wide conveyors) with an incline of 18 degrees. The exception to this are as follows: Overland conveyors (C-61, and C-62) were designed for 950 STPH for the 30" wide conveyors with a lift 25 feet; Reject Transfer conveyor was designed with a lift 30 feet; Tunnel conveyor (C-23) was designed with a lift 50 feet; Screen Overs Transfer conveyor (C-48 was designed with a lift 30 feet; and Zone 3 Transfer conveyor (C-55) was designed with a lift 40 feet;. All conveyor motors are were sized by taking the belt tonnage listed in each of the conveyor descriptions times 125% and then increased one size to have better cooling because of the altitude.

These descriptions were prepared to the best efforts of IMCE. We encourage all potential purchasers to inspect the equipment and verify the details.