Consists of:

• Water tub constructed from 5/16" thick ASTM A-36 certified structural quality steel
• Center mounted rising current structure
• Overflow weir on two sides
• 150 HP 3/60 230/460 TEFC electric motor
• Externally mounted lower end greaseable pillow block bearings
• Totally enclosed sealed oil bath gearbox with flange bearings and twin helical synchronized precision gears
• V-belt drive complete with V-belt guard
• Spiral type, twin synchronized shafts for continuous material motion to reduce drive
• System shock loading
• Adjustable ni-hard wear paddles
• Skid frame base for extra machine rigidity and pit mobility
• Clean-out drain assembly
• Discharge chute
• Support Legs

Note: A log washer feed bypass chute with flop gate will also be included.

Photos

Contact / Additional Info

Please contact Mickey Jones at (303) 514-1403 email mickeyhk@hotmail.com or Greg Jones at (303) 885-2068 email greg@intermountaincrushers.com for further information.

Note: Each of the conveyors mechanical components (frame, bearings, shafting, gear boxes, take-ups, etc.), except motors are designed for 950 STPH for the 30" wide conveyors (1300 STPH for 36" wide conveyors) with an incline of 18 degrees. The exception to this are as follows: Overland conveyors (C-61, and C-62) were designed for 950 STPH for the 30" wide conveyors with a lift 25 feet; Reject Transfer conveyor was designed with a lift 30 feet; Tunnel conveyor (C-23) was designed with a lift 50 feet; Screen Overs Transfer conveyor (C-48 was designed with a lift 30 feet; and Zone 3 Transfer conveyor (C-55) was designed with a lift 40 feet;. All conveyor motors are were sized by taking the belt tonnage listed in each of the conveyor descriptions times 125% and then increased one size to have better cooling because of the altitude.

These descriptions were prepared to the best efforts of IMCE. We encourage all potential purchasers to inspect the equipment and verify the details.